Cub Cadet LT1040 Operator's Manual page 22

Fuel Filter
WARNING:
when engine is hot.
The engine is equipped with an inline fuel filter located
on the right side of the engine.
Visually inspect the filter periodically for a build-up of
residue inside the filter body, and for a dirty element
which can be indicated by discoloration. Replace the
fuel filter when dirty.
Cleaning the Engine And Deck
Any fuel or oil spilled on the machine should be wiped
off promptly.
Do NOT allow debris to accumulate around the cooling
fins of the engine or on any other part of the machine,
especially the belts and pulleys.
Smart Jet™
Your tractor's deck is equipped with a water port on its
surface as part of its deck wash system.
Use the Smart Jet™ to rinse grass clippings from the
deck's underside and prevent the buildup of corrosive
chemicals. Complete the following steps AFTER EACH
MOWING:
1. Drive the tractor to a level, clear spot on your lawn,
near enough for your garden hose to reach.
Make certain the tractor's discharge chute
IMPORTANT:
is directed AWAY from your house, garage, parked
cars, etc.
2. Disengage the PTO (Blade Engage), set the
parking brake and stop the engine.
3. Thread the hose coupler (packaged with your
tractor's Operator's Manual) onto the end of your
garden hose.
4. Attach the hose coupler to the water port on your
deck's surface. See Figure 13.
Water Port
Figure 13
Do not replace the fuel filter
Hose Coupler
5. Turn the water on.
6. While sitting in the operator's position on the
tractor, start the engine and place the throttle lever
in the FAST (rabbit) position.
7. Move the tractor's PTO (Blade Engage) into the ON
position.
8. Remain in the operator's position with the cutting
deck engaged for a minimum of two minutes,
allowing the underside of the cutting deck to
thoroughly rinse.
9. Move the tractor's PTO (Blade Engage) into the
OFF position.
10. Turn the ignition key to the STOP position to turn
the tractor's engine off.
11. Turn the water off and detach the hose coupler
from the water port on your deck's surface.
Lubrication
WARNING:
inspecting, always disengage PTO, set
parking brake, stop engine and remove key to
prevent unintended starting.
Engine
Refer to Engine on page 19 for instruction regarding all
engine-related lubrication.
Front Wheels
Each of the front wheel axles and rims is equipped with
a grease fitting. See Figure 14. Lubricate with a No. 2
multi-purpose grease applied with a grease gun after
every 25 hours of tractor operation.
Axle Grease Fitting
Rim Grease Fitting
Pivot Points & Linkage
Lubricate all the pivot points on the drive system,
parking brake and lift linkage at least once a season
with light oil.
22
Before lubricating, repairing, or
Figure 14