Use Your Tv; Switching On Your Tv Or Putting It In Standby Mode; Adjusting Volume; Switching Channels - Magnavox 28MD403V Owner's Manual

4 Use your TV

Switching on your TV or putting it in Standby
mode
* Control Keys are on Top side of unit
TV
To Turn the TV On from Standby or Off to Standby
• Press on the Top side of the unit or the Remote Control.
Note(s)
• Energy consumption contributes to air and water pollution. When the AC Power cord
is plugged in, your TV consumes energy with a very low Standby Power consumption.

Adjusting volume

* Control Keys are on Top side of unit
TV
To decrease or increase volume
• Press VOL / on the Top side of the unit or press VOL + /
on the Remote Control.
VOL : Volume Down
VOL : Volume Up
To mute or unmute sound
• Press on the Remote Control to mute the sound.
again or VOL + /
• Press
Remote Control
Remote Control
to recover the original sound.

Switching channels

* Control Keys are on Top side of unit
TV
To select Channels by using CH
Press CH
• (Down) / (Up) on the Top side of the unit or press
CH + / on the Remote Control.
To select Channels by using the NUMBER keys
Digital TV operation
• For Digital channels, press a number followed by a dot "•" and the
corresponding sub channel number.
– When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
Analog/Cable TV operation
– When selecting cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note(s)
• To select the non-memorized channels, use the NUMBER keys.
• No Signal will appear on the TV Screen after the subchannel broadcast is over.
• Audio only program message will appear on the TV Screen, when you receive only
sound signal.
18
Remote Control
/ or CH + /
Continued on next page.
English