Initial Setup - Magnavox 28MD403V Owner's Manual

These operations are accessible by Remote Control.
Some may also be accessible by control panel on the main unit.

Initial setup

This section will guide you through the unit's Initial setting which includes
selecting a Language for your On-screen Menu and Autoprogram, which
automatically scans and memorizes viewable channels.
Before you begin:
Make sure the unit is connected to an Antenna or Cable.
1
After making all the necessary connections, press
unit.
• It may take a few moments to Turn On the unit for the first time.
• Initial setup menu appears automatically after the unit is Turned
On.
2
Use to select the On-screen language from the choices
(English / Español / Français) on the right side of the TV Screen,
then press OK.
3
to select Antenna for TV channels or Cable for CATV
Use
channels, then press OK.
Initial setup
Make sure the antenna is connected to "ANTENNA IN'' jack.
Select your signal source.
Antenna
Cable
Or
Select OK
– When Antenna is selected, the TV detects antenna signals. It
searches for DTV and Analog TV channels available in your area.
– When Cable is selected, the TV detects signals supplied by cable.
It searches for DTV, Analog TV and Cable channels available in
your area.
• Autoprogram will begin.
Initial setup
Please wait while the system is scanning for channels.
Auto programming may take more than 20 minutes to
complete.
Digital channels
Analog channels
to Turn On the
Antenna
Cable
Skip
ANTENNA IN
Back Skip
0 ch
0 ch
Skip
4
Use to select the desired Location setting, then press OK.
Home is the ENERGY STAR
Initial setup
Location Home is recommended for normal home use
and is ENERGY STAR qualified.
In the Retail Store mode, all settings are fixed.
Select
• Select Retail, the unit will be set up with predefined setting for
retail displays. In this setting, the power consumption may
possibly exceed the limited requirement limit of the ENERGY
®
STAR qualification.
• Select Home, the unit is set to maximize the energy efficiency for
home setting and it can be adjusted through a choice of Picture
and Sound quality according to your preference. Use this setting
to remove the E-sticker if visible from the display. ➟ p.30
• When the Initial setup is completed, the lowest memorized
channel with the confirmation message of the Location setting
will be displayed on the TV Screen.
• You must set Home in step 4. Otherwise, Picture and Sound
settings you adjusted will not be memorized after the unit goes
into Standby mode.
Note(s)
• If you are not receiving a signal from your cable service, contact the Cable provider.
• If you press or TV MENU during Autoprogram, this setup of TV channels will be
Cancelled.
• The Initial Autoprogram function can be executed for either Antenna or Cable only
once. When you change the connection (Antenna / Cable), select Autoprogram
again. ➟ p.23
• If there is no signal Input from the Antenna terminal and no operation for several
seconds after you Turn On the unit, Helpful hints appears. Follow the instructions
listed on the TV Screen.
Initial setup
No channel is registered.
Try Autoprogram again?
Verify that you have a cable connected to the "ANTENNA IN" jack
on the back of the TV, the channel installation process
searches this connection. If you are using a cable or satellite
box, please confirm the input which you have connected to
the box and press "SOURCE" key on the remote control to
select the appropriate source input.
Select OK
After an Initial setup is completed...
• If you want to scan the channels automatically again.
Autoprogram ➟ p.23
• You can add the desired Cable and Analog channels not
memorized by Autoprogram.
Add channels ➟ p.24
• If you want to change to another Language.
Language ➟ p.30
• If you want to change the Location setting.
Location ➟ p.30
®
qualified setting.
Retail
Home
OK
Retry
Later
Skip
17
English