Connection - Motorola 2247-N8 User Manual

Connection

Use the Connection page to change the way you connect to your Internet Service Provider (ISP). You should only change these settings when your ISP
requires it.
: always remember to click Apply Changes to make sure your updates are saved.
Important
DSL Auto Modulation
: If this check box is selected (default setting), your 2247-N8 will use automatic rate adaptation, which tries to sync at
the fastest possible modulation.
Auto Detection VPI/VCI
trying the most common settings until one is found. Thereafter, the 2247-N8 will always attempt to use that pair. If the 2247-N8 cannot
detect the VPI/VCI set in use, you can clear the check box, and enter the values manually. VPI 0 and VPI 35 and VPI 8 and VCI 35 are the most
common virtual circuit pairs used. Always try auto-detection first and then contact your service provider if another value is required.
Encapsulation
: ether-llc (this is the only option)
PPPoE
: Point to Point Protocol over Ethernet (PPPoE) is the most commonly used configuration by DSL service providers. To use PPPoE,
select the check box, enter the information below, and click
PPP Username
PPP Password
Confirm Password
Connection Type - Select always-on (default) to make sure your 2247-N8 is always connected to the Internet. If you choose on-demand,
your 2247-N8 will establish a connection to the Internet only when a request is made from your home network. You can use the User
www.motorola.com/us/support
Please visit
: If this check box is selected (default setting), your 2247-N8 will attempt to detect the virtual circuit pairs in use by
for FAQs and additional product documentation.
Configure Connection Page
Apply Changes.
Motorola 2247-N8 DSL Wi-Fi Gateway User Guide
17