Table of Contents
Advertisement
settings for your personal taste. If
the grinder is unplugged it will re-
tain the stored settings.
Sleep Mode
To minimize standby power con-
sumption, the Forté
into "sleep mode" automatically af-
ter 5 minutes of non-use. While in
sleep mode, the screen goes
blank. To "wake up" your Forté
press any button. Once the screen
lights up, select your grinding
method.
PortaHolder
and Installation
Place the PortaHolder
surface and check to see if your
porta filter fits onto the two steel
bars and sits level. The steel sup-
port bars can be adjusted verti-
cally by loosening the two Phillips
screws on the back of the Porta
Holder. Once you have the correct
vertical position for the bars, tight-
en the screws. Insert the PortaHol-
der
into the grinder and press it
™
rearward until fully installed. Make
sure not to put any pressure on the
load cell. Then insert the porta fil-
ter into the PortaHolder
the handle up so the front lip of the
porta filter slides under and gets
hooked by the hook bracket on
the under side of the funnel shape
Porta-Holder
. To use, insert your
™
porta filter into the PortaHolder
will go
TM
,
TM
Set-up
™
on a flat
™
by lifting
™
.
™
8
Press TIME and the desired preset
dose button, then press START.
The grinder will run for the preset
dose time and stop automatically.
Forté
Burr Calibration
TM
Note
All directional indications assume
you are looking down on the
machine.
A 2 mm Allen head calibration
screw is located in the round hole
behind the discharge chute (see
photo). This calibration screw
allows the user to easily fine tune
the calibration of the burr in the
finer or coarser direction while the
grinder is running. To make the
adjustment, empty all beans from
the grinder. Turn the grinder on
and lower the Macro and Micro
levers all the way to the bottom.
Let the grinder run long enough
to expel any remaining ground
coffee. With the bin removed,
TARE the grinder. Now press any
one of the preset buttons then
press START. The grinder will run
until you press the STOP button
or 3 minutes elapses. For a finer
grind, while the grinder is running,
move the Macro arm up to the top
(setting 1). You should not hear
any change in motor speed. Now
slowly move the Micro arm up to
the top (setting A). If the motor
hasn't started to slow, use the tool
Hide quick links:
Advertisement
Table of Contents
