Using The Anynet+(Hdmi=Cec); Using The Tv Functions; Software Upgrade - Samsung HW-F550 User Manual

Using the Anynet+(HDMI=CEC) function
Anynet+ is a function that enables you to control other Samsung Devices
with your Samsung TV's remote control.
The Anynet+ function turns on and off each time you press Anynet+.
1. Connect the product to a Samsung TV with an HDMI cable.
(See page 13)
2. Set the Anynet+ function on your TV and the SAT to ON. (See the
TV instruction manual for more information.)
TV VOL TV CH /b2{J _, l"
_/I__ TV INFO TV pRE,CH TV EXLT
,_ Depending on your TV, certain HDMI output resolutions may not
work.
,_ Please refer to the user's manual of your TV and check for the
4;;y_: logo (If your TV has an 4;;_._Clogo, then it supports the
Anynet+ function.)
Using the TV functions (with Samsung TVs only)
• Press TV SOURCE on the remote control to change the TV's input source.
Press TV INFO on the remote control to display the TV channel
information.
Press TV CH on the remote control to select the TV channel.
Press TV VOL on the remote control to increase or decrease the volume
level.
,, Use TV PRE-CH button to move to the previous TV channel in TV mode.
• Toexit the TV menu, use the TV EXIT button. (It functions the same as the
EXITbutton of the TV remotecontrol.)
SOFTWARE UPGRADE
When you press the SoundShare button, the TV's sound is
transmitted through the Air Track system via a Bluetooth
connection. The Air Track also controls the sound volume,
sound quality, etc.
The remote control can operate TVs made by SAMSUNG only.
Samsung may offer upgrades for the Crystal Surround Air Track's
system firmware inthe future.
If an upgrade is offered, you can upgrade the firmware by connecting a
USB drive with the firmware upgrade stored on it to the USB port on
your Air Track.
Note that if there are multiple upgrade files,you must load them onto the
USB drive singly and use them to upgrade the firmware one at a time.
Pleasevisit Samsung.com or contact the Samsung call center to receive
more information about downloading upgrades files.
22
,_,Insert a USB drivecontainingthe firmware upgrade into the USB port on the mainunit.
,_,Do not disconnectthe power or removethe USB drivewhile upgradesare being applied.The main unit will turn
oft automaticallyafter completing the firmwareupgrade.
When softwareis upgraded, settingsyou have made will returnto their default (factory)settings.
We recommendyou write down your settings so that you can easilyreset them after the upgrade.
,_,Once upgradingthe product softwareis completed, turn oft the product and then press and hold (=) button for
a whileto resetthe product.
,_,Ifthe firmware failsto upgrade, we recommendformatting the USB device in FAT16and trying again.
,_,For upgrading purposes, do not format the USB drivein NTFSformat becauseit is not a supported filesystem.
,_,Dependingon the manufacturer,some USB devices may not be supported.