Adjusting Focal Length (Zoom) And Focus; Advanced Setup - Bosch AutoDome VG4-100 Series User Manual

AutoDome Modular Camera System
4

Adjusting Focal Length (Zoom) and Focus

To adjust the camera lens focal length and focus, perform the following steps:
1.
2.
3.
4.
5.
6.
7.
Focus & Zoom
Lock Screws
Fig. 4.1 Focus and Zoom Adjustment
5

Advanced Setup

The VG4-100 Series camera module normally provides an optimal picture without the need for
further adjustments. Advanced setup options, however, are available for obtaining the best
results from the camera under special circumstances. There are two upper level On-Screen
Display (OSD) menus: the Main menu and the Install menu.
The Main menu allows you to select and setup the picture enhancement functions. The Install
menu allows you to set the camera ID, focus and synchronization settings. The Main and
Install menus have settings that you can select directly or open to submenus for a more
detailed setup.
NOTICE! Active menu selections can vary depending or the combination of camera, CPU and
i
COMM (communication) modules used. The menu selections described in this manual are
typical for a VG4-100 Series system.
Bosch Security Systems, Inc.
Select Set Focus Now from the Install menu.
To adjust the focal length, loosen the focal (zoom) lock screw and rotate the lens mecha-
nism (WIDE or TELE.) until you achieve the desired field of view. See Figure 4.1below.
To focus the image on the monitor, loosen the focus lock screw and turn the lens mecha-
nism (NEAR or FAR) until the image is in focus.
Repeat both these adjustments until the desired view is in focus.
Tighten both adjustment screws.
Exit the Install menu.
Remove the monitor jack and replace the covert liner and dome bubble when finished.
Focus and Zoom
Lock Screws
VG4-100 Series User's Manual
Adjusting Focal Length (Zoom) and Focus | en
F01U028033 | 1.0 | 2006.08
5