Manual Camera Settings; Adjusting Focus, Focal Length, Pan, And Tilt; Accessing The Rear Controls - Bosch NEI-Series User Manual

30 en | Manual Camera Settings
6

Manual Camera Settings

Most camera settings can be adjusted remotely via CTFID
software (for analog models; refer to the Configuration Tool for
Imaging Devices User Manual at www.boschsecurity.com) or via
the web browser interface (for IP models). Some settings--lens
focus, focal length, pan, tilt, LED tilt, and the width of the
illumination beam--require manual adjustment using controls at
the back of or in the front of the camera.
6.1 Adjusting Focus, Focal Length, Pan, and
Tilt
To adjust the focal length and focus, use the controls located
on the access panel at the rear of the camera housing. An
access panel also contains the camera keypad buttons that you
use to interact with the camera's on-screen display (OSD)
menu. This menu provides advanced set-up options for getting
the best results under special circumstances.
6.1.1

Accessing the Rear Controls

1.
Figure 6.1 Rear camera housing with access panel
2.
F.01U.263.416 | 3.1 | 2012.09
Unscrew the four (4) captive screws (item 1 in Figure 6.1)
of the access panel on the rear of the camera housing.
Open the access panel. Now you can adjust the focus and
focal length (see Figure 6.2 below).
Note: Before you make any adjustments, you may need to
connect the camera to a monitor to view the changes to
the picture. See Section 5 Ethernet Connection (IP models),
User Manual
Dinion IP Infrared Imager
Bosch Security Systems, Inc.