Table of Contents
Advertisement
Fused electrical supply is required-copper wire only. Time delay fuse or c ircuit breaker recommended and provide separate
circuit serving only this appliance. Outlet should be placed in adjacent cabinet.
Make sure that the plug on the appliance remains accessible after installation.
Connector of ModelⅠ
A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has one, it is
recommended thet the hose be disconnected and the hole plugged.
1
Turn off the water.
2
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the
room, from severe splashing.
3
Release Unicouple from faucet by depressing the collar at the top of the Unicouple connector.
1
Remove the power cord plug from the wall receptacle.
2
Disconnect Unicouple from faucet adapter.
After making sure that the voltage and the frequency values for the current in the home
correspond to those on the rating plate and that the electrical system is sized for the
maximum voltage on the rating plate, insert the plug into an electrical socket which is
earthed properly. If the electrical socket to which the appliance must be connected is not
appropriate for the
plug
using a adaptors or the like as they could cause overheating and burns.
The appliance must be connected to the water mains using new hose-sets.
The old hose-sets should not be reused.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below the minimum
consult our Service Department for advice.
If faucet has not threads: attach the faucet adapter to faucet, then tighten every screw
of the adapter. To prevent leaking your should tighten the adapter.
1
Pull Unicouple and its hoses completely out from storage compartment located at rear of dishwasher
and attach it to the faucet adapter.
2
Attach the Unicouple connector to the faucet adapter by depressing the collar at the top of the connector.
When Unicouple is all the way up onto the adapter, release the collar. It will then snap Into position to
lock the Unicouple in place. The Unicouple s small hose carries water from the faucet to the dishwasher.
Its large hose carries drain water to the sink. Be sure Unicouple is pointing toward the sink bowl drain
opening and the sink drain is open for water that will drain from your dishwasher. If your dishwasher
drains into a disposer, operate the disposer until it is completely empty before starting the dishwasher.
3
Turn water fully on before starting the dishwasher.
, replace the socket
(installed by a qualified electrician)
'
10
,rather than
Hide quick links:
Advertisement
Table of Contents
