Filtering System; Caring For The Dishwasher; Cleaning The Spray Arms; Cleaning The Filters - Candy CFD 612-80 Instruction Manual

Table of Contents

Advertisement

The filter prevent larger remnants of food or other objects from getting inside the pump. This residue can
occasionally clog up the filters.
2
1
3
It is necessary to cl ean the spray arms regularly for hard water chemicals will clog the spray arm jets and bearings. To remove the
spray arm, screw off the nut to take out the washer on top of the spray arm and remove the arm. Wash the arms in soapy and warm
water and use a soft brush to clean the jets. Replace them after rinsing them thoroughly.
Never run the dishwasher without the filters in place.
The filter system consists of a filter cylinder(Coarse filter),
A flat (Main filter) and a microfilter(fine filter).
Main filter
Food and soil particles trapped by this filter are pulverized by a
special jet on the lower spray arm and washed down the
drain.
Coarse filter
Larger items, such as pieces of bone or glass, that could clog
the drain are trapped in the coarse filter. To remove an item
caught in this filter, gently squeeze the taps on the top of this
filter and lift it out.
Fine filter
This filter holds soil and food residue in the sump area and
prevents it from being redeposit on the dishes during a cycle.
If your dishwasher is left in an unheated place during the winter, ask a service technician to:
1
Cut off electrical power to the dishwasher. Remove
fuses or trip circuit breaker.
2
Turn off the water supply and disconnect the water
inlet pipe from the water valve.
3
Drain water from the inlet
(Use a pan to catch the water.)
Filter assembly
For best performance and results, the filter assembly must be cleaned.
The filter efficiently removes food particles from the wash water, allowing it to be
recirculated during the cycle. For this reason, it is a good idea to remove the larger
food particles trapped in the filter after each wash cycle by rinsing the se micircular
filter and cup under running water. To remove the filter assembly, pull on the cup
handle in the upward direction. The entire filter assembly should be cleaned at least
once a month.
To clean the coarse filter and the fine filter, use a cleaning brush. Then, reassemble
the filter parts as shown in the figures left and reinsert the entire assembly in the
dishwasher, positioning in its seat and pressing downward.
The dishwasher must never be used without the filters. Improper replacement of the
filter may reduce the performance level of the appliance and damage dishes and utensils.
1
2
3
pipe
and water valve.
8
4
Reconnect the water inlet
water valve.
5
Remove the plastic sump cover in the
tub the bottom and use a sponge to
soak up water in rubber boot.
pipe
to the

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cfd 612s-80

Table of Contents