Table of Contents
Advertisement
Available languages
Available languages
STRETCH
HOSE
ASSEMBLY
Attach
stretch
hose to hose coupling
on
nozzle as shown.
Make sure stretch hose
is firmly connected
prior to using the vac-
uum.
Remove
tape located
l
on the back of the
unit,
CORD ASSEMBLY
Make sure the quick release
cord hook is
in the upright
position,
Remove
the wire
tie from the power cord.
Lock the cord
into place by
forcing
it into the
locking notch on
the body of the
upper cord hook
as shown, This
helps keep the
power cord out
from under the
vacuum
cleaner
agitatoro
Quick
Release Cord
Hook -_-*.
Power
Lower
Cord
Wrap the
power cord
around the
quick release
and lower
cord hooks
and lock the
power cord
plug onto the
power cord.
HOW TO START
_iil
Quick
"_--- Release
Hook
1. Turn the
quick
release cord
hook to
either side
and down to
release the
power cord.
2. Release
the power cord plug from the
power cord and pull the cord off the quick
release
cord hook, Check to be sure the
power cord is still locked
into the lock in
the quick release
cord hook.
3. Check
to see if the cleaner
has bag
installed.
See DUST BAG CHANGING°
NOTE: To reduce the risk of electric
shock, this vacuum
cleaner
has a polar-
ized plug, one blade is wider than the
other. This plug will fit in a polarized
outlet
only one way. If the plug does not fit fully
in the outlet,
reverse the plug. If it still
does not fit, contact
a qualified
technician
to install the proper
outlet. Do not change
the plug in any way.
4. Plug the polarized
power cord into a
120 Volt outlet located
near the floor.
WARNING
Personal
Injury and Product Damage
Hazard
• DO NOT plug in if switch is in the ON
position. Personal injury or damage
could result,
• DO NOT use outlets above counters.
Damage to items in surrounding area
could occur,
Advertisement
Table of Contents
