Fx Cruiser Sho; Checking And Adjusting The Throttle Cable - Yamaha FX SHO: FX Cruiser Owner's Manual

Maintenance and care
If the reverse gate does not make contact with
the stopper, have a Yamaha dealer service it.
EJU37030
Checking and adjusting the throttle
cable
Face the handlebars straight ahead, and then
check that the throttle cable moves back to
the set position smoothly and that the throttle
lever free play is within specification.
Squeeze and release the throttle lever. If the
throttle lever does not return smoothly, have a
Yamaha dealer service it.
If the specified throttle lever free play cannot
be obtained as described below, have a
Yamaha dealer make the adjustment.
FX SHO
(1) Remove the eight screws, and then re-
move the front handlebar cover.
1 Front handlebar cover
(2) Slide the rubber cover away from the ad-
juster, and then loosen the locknut.
95
(3) Make sure that the handlebars are facing
straight ahead, and then adjust the free
play by turning the adjuster.
1 Rubber cover
2 Locknut
3 Adjuster
4 Throttle lever free play
Throttle lever free play:
2.0–5.0 mm (0.08–0.20 in)
(4) Hold the adjuster with one wrench while
tightening the locknut with another
wrench. Slide the rubber cover to its orig-
inal position.
(5) Install the front handlebar cover, and then
install the eight screws.

FX Cruiser SHO

(1) Remove the ten screws, and then re-
move the front and rear handlebar cov-
ers.
1 Front handlebar cover
2 Rear handlebar cover