Table of Contents
Advertisement
o
While lowering the needle threader lever,
hook the thread onto the guide.
a Needle threader
b Thread
c Guide
p
Catch the thread on the hook as shown below.
a
a Needle threader lever
q
Raise the needle threader lever, and then pull
the end of the thread which passed through
the eye of the needle.
CAUTION
● Be careful not to pull on the thread with force
or it may bend the needle.
r
Raise the presser foot lever, pass the end of
the thread through the presser foot, and then
pull out about 5 cm (2 inches) of thread
toward the rear of the machine.
a 5 cm (2 inches)
The upper threading is finished.
■ Manually threading the needle
When using specialty thread, such as transparent
nylon thread or metallic thread, a wing needle or
a twin needle which cannot be used with the
needle threader, thread the needle as described
below.
a
Thread the machine following steps
m
through
of "Threading the upper thread",
and then lower the presser foot lever.
b
Manually pass the thread through the eye of
the needle from front to back.
CAUTION
● Do not touch the
button),
(needle position button) or
(reverse/ reinforcement stitch button). If
one of the buttons is accidentally pressed,
the machine will begin sewing and your
finger may be pricked with the needle or
the needle may break.
a
a
/
(start/stop
23
1
Hide quick links:
Advertisement
Table of Contents
