Display - Kenmore 580.75052 Owner's Manual

DISPLAY
REMOTE CONTROL SIGNAL RECEIVER
TEMPERATURE SETTING
• This button can automatically control the temperature
of the room. The temperature can be set within a range of
60°F to 86°F by increments of I°F.
MODE
- Every time you push this button, it will shift among
COOL, ENERGY SAVER and FAN.
- ENERGY SAVER:
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.
TIMER
- SHUT-OFF TIME
• If unit is running, Timer sets number of hours until shut-off.
• Every time you push Timer button, it advances the Timer
setting as follows: 1 Hour _,2 Hours _,etc._.12 Hours
maximum.
- START TIME
• If unit is off, Timer sets number of hours before unit starts.
• Every time you push Timer button, it advances the Timer
setting as follows: 1 Hour _. 2 Hours _,etc._.12 Hours
maximum.
-- POWER
• To turn the air conditioner ON, push the button. To turn the air
conditioner OFF, push the button again.
• This button takes priority over any other button.
• When you first turn it on, the unit is in cool mode, High fan
speed, Temperature setting at 72°F.
FAN SPEED
• Every time you push this button,it advancesthe settingas
follows: {High _.Low_"Med _.High}
In failure of electric power, the unit runs as previous setting operation.
-10-