Port Leds And Modes - Cisco Catalyst 2900 SERIES XL Hardware Installation Manual

Chapter 1 Product Overview
Table 1-4 RPS LED on the Catalyst 2912 LRE XL and 2924 LRE XL Switches (continued)
Color RPS Status
Solid amber RPS is connected but not functioning properly.
•
•
•
Blinking amber Internal power supply of the switch is down, and redundancy is lost. The switch is
operating on the RPS.

Port LEDs and Modes

Table 1-5 Port Mode LEDs on the Catalyst 2912 XL, 2924C XL, 2924 XL, 2924MF XL, and 2924M XL
Switches
Mode LED Port Mode
STAT Port status
UTL Switch utilization
FDUP Port duplex mode
100 Port speed
78-6461-03
The RPS could be in standby mode. Pressing the Standby/Active button the
RPS puts it in Active mode, and the LED should turn green.
One of the power supplies in the RPS could be powered down.
A fan in the RPS might have failed.
Each of the 10/100, 100BASE-FX, and LRE ports and module slots have a port
LED. These port LEDs, as a group or individually, display information about the
switch and about the individual ports. The port modes
determine the type of information displayed.
To select or change a mode, press the Mode button until the desired mode is
highlighted. When you change port modes, the meaning of the port LED colors
also changes. Table 1-7and
Description
The port status. This is the default mode.
The current bandwidth in use by the switch. (See
The port duplex mode: full duplex or half duplex.
The port operating speed: 10, 100, or 1000 Mbps.
Table 1-8 list the port LED colors.
Catalyst 2900 Series XL Hardware Installation Guide
100BASE-FX Ports
(Table 1-5 and Table 1-6)
Figure 1-7.)
1-13