Cisco uBR10012 Software Configuration Manual page 189

Chapter 4 Managing Cable Modems on the Hybrid Fiber-Coaxial Network
Command
cable sync-interval msec
no cable sync-interval
Verifying Sync Message Interval
To determine if a sync message interval is configured, enter the show running-config command and
look for the cable interface configuration information. If the sync message interval is deactivated or reset
to its default value, the
OL-1520-05
Purpose
Specifies the interval in milliseconds between successive sync
message transmissions from the Cisco uBR10000 series CMTS.
Valid values are from 1 to 200 msec. Default = 10 msec.
Returns the sync message interval to its default value of 10 msec.
command line appears in the output.
no sync interval
Cisco uBR10012 Universal Broadband Router Software Configuration Guide
Configuring Sync Message Interval
4-11