Extend the server from the rack (on page 25).
2.
Open the locking latch, slide the access panel to the rear of the chassis, and remove the access panel.
3.
If the locking latch is locked, use a T-15 Torx screwdriver to unlock the latch.
Install the access panel
Place the access panel on top of the server.
1.
Slide the access panel forward until it clicks into place.
2.
Remove the processor memory drawer
Power down the server (on page 25).
1.
Remove the processor memory drawer shipping screws, if installed. Retain the screws for future use.
2.
Release the latches on the release lever.
3.
Lower the handle, and then extend the processor memory drawer from the server until the release
4.
latches catch.
WARNING:
caution when removing and replacing the processor memory drawer.
The processor memory drawer weighs more than 11.3 kg (25.0 lb). Use extra
Operations 27