Motorola 68390 - Vanguard 320 Router User Manual page 79

A p p l i c a t i o n V i e w s
Table 20: HybridEAndM2 Filters
Filter
sixHundred 600 ohm interface for USA, Japan and
Ireland.
Germany 220 ohms in series with (820 ohms in
parallel with 115nF).
UK 370 ohms in series with (620 ohms in
parallel with 310nF).
nc Skipped during configuration.
signallingMode
Select the voice signalling mode.
displays the valid signalling modes:
Table 21: Signalling Mode
signalling Mode
normal Allows signalling to pass end to end
and signalling will be used to control
circuit state and packet flow.
node A permanent voice path is established
and packet flow is always enabled, but
no signalling will be passed through.
nc Skipped during configuration.
D e v i c e M a n a g e m e n t
Description
Table 21
Description
signallingContro
Select signalling control transmission mode in
E&M interface type.
signalling control modes:
Table 22: Signalling Control Transmission
Mode
immediate
wink
transparent
delay
masterColisee
slaveColisee
seizureAcknowledge
nc
This value will be nc for FXO & FXS type
interface.
Page 79
S u p p o r t e d A p p l i c a t i o n s
Table 22 displays valid
Description
Digits are transmitted immediately.
Digits are transmitted after the
WINK pulse.
The voice signalling states are
transmitted end to end without
interpreting the signalling state.
Digits are transmitted after the end
of the Delay Dial signal.
65xx is simulating Colisee master
mode.
65xx is simulating Colisee slave
mode.
Transmit Seizure acknowledge
immediately after receiving a
Seizure signal from the PBX.
Skipped during configuration.
M o t o r o l a V a n g u a r d