Table of Contents
Advertisement
After the paper has started to be taken into the printer, continue to press the LOAD/
PARK button and the paper is taken into the 6.35 mm (0.25 in) position.
5.
Align the paper with the first print line position as follows:
In off-line mode, press the following buttons to adjust the first printing line:
To feed the paper forward by a small amount, hold down the LOAD/PARK button and
then press the SEL button.
To feed the paper backward by a small amount, hold down the LOAD/PARK button
and press the LF/FF button.
NOTE
If the specified correction range is more than +-7/60 in, the ALARM indicator
flashes and the paper cannot be moved.
6.
When the paper is positioned at the required TOF, release the buttons in Step 5
above.
To save this position as the TOF, press and hold the SEL button and then press the
LF/FF button.
P
RINTER SETTINGS
P
RINTER IMPACT MODE
When switched ON, the printer enters the impact mode selected in the menu. You can
change this to normal
Emphasis printing
Do not use emphasis printing if performing horizontal tab character
printing on thin paper as the paper may become damaged.
Use this for printing multipart forms.
You have to set emphasis printing by using the menus to set Impact Mode to Hi Copy as
described in
"Menu setting" on page
NOTE
>
If the paper on top is so thick that duplication on the paper below it fails,
use emphasis printing.
>
In emphasis printing mode, printing is carried out twice.
>
The print may become blurred if high density characters and graphics are
printed using a new ribbon.
>
In emphasis mode, ensure that the paper is flat to avoid possible printing
errors.
speed,
quiet printing or Emphasis printing.
CAUTION!
26.
Operating instructions > 34
Advertisement
Table of Contents
