HCD-EC709iP/EC909iP
2-8.
FRONT PANEL BLOCK
1 flexible flat cable (25 core)
9 front panel block
(CN603)
4 filament
8 claw
8 claw
7 two screws (BVTP3 K 10)
2-9.
KNOB (VOL)
Note: This illustration sees the front panel block from PANEL board side.
2 knob (VOL)
hole
10
3 Remove clamping.
5 sheet
tape
6 connector (CN103)
2 flexible flat cable (5 core)
(CN102)
PANEL board
Note 1: Confirm it is unquestionable for
the open/close of the iPod dock
after the lead wire is processed.
Note 2: Confirm the lead wire in
clamp (L35)
– Side view –
front panel block
1 Push the knob (VOL) by flat-head screwdriver.
sheet
filament tape
this part does not stretch.
filament tape
clamp (L35)
– Top view –