Advertisement
The operation ofanytractor canresult i nforeign o bjects thrown i ntothe
eyes, which c anresult
in severe eye damage. Always wear safety glasses
or eye shields while operating your tractor or performing any adjustments or
repairs. We recommend a wide vision safety mask over spectacles, or stan-
dard safety glasses°
HOW TO USE YOUR TRACTOR
Your tractor is equipped with an operator
presence sensing switch. When engine is
running, any attempt by the operator to
leave the seat without first setting the
parking brake will shut off the engine.
TO SET PARKING BRAKE
,, Depress clutch/brake pedal into full
"BRAKE" position and hold
_, Place parking brake lever in "EN -
GAGED" position and release pressure
from clutch/brake
pedal. Pedal should
remain in "BRAKE" position. Make sure
parking brake will hold tractor secure.
Throttle/Choke
Attachment Clutch Lever
Control
"Engaged" Position
"Disengaged"
Position
Clutch/Brake
_--Motion
Pedal "Drive"
gaged"
Control
Position
Position
Lever
STOPPING
MOWER BLADES -
To stop mower blades, move attach-
ment dutch lever to "DISENGAGED"
position.
GROUND DRIVE -
To stop ground drive, depress
clutch/brake pedal into full "BRAKE"
position.
_, Move motion control tever to neutral (N)
position.
IMPORTANT: The motion'control
lever
does not return to neutral (N) position
when the clutch/brake pedal is depressed.
ENGINE
Move throttle control to slow position.
NOTE:
Failure to move throttle control to
slow position and allowing engine to idle
before stopping may cause engine to
"backfire _.
Turn ignition key to "OFF' position and
remove key. Always remove key when
leaving tractor to prevent unauthorized
use.
o Never use choke to stop engine.
IMPORTANT:
Leaving the ignition switch
in any position other than "OFF" will cause
the battery to be discharged, (dead).
NOTE:
Under certain conditions when
tractor is standing idle with the engine run-
ning, hot engine exhaust gases may
cause "browning" of grass. To eliminate
this possibility, always stop engine when
stopping tractor on grass areas.
_, CAUTION:
Always stop tractor com-
pletely, as described above, before leaving
the operator's position; to empty grass
catcher, etc.
THROTTLE
CONTROL
Always operate engine at full throttle
- Operating engine at less than full throt-
tle reduces the battery charging rate.
Full throttle offers the best bagging and
mower performance.
TO MOVE FORWARD AND BACKWARD
The direction and speed of movement is
controlled by the motion control lever.
Start tractor with motion control lever in
neutral (N) position.
* Release parking brake and clutch/brake
pedal.
Slowly move motion control lever to
desired position.
TO ADJUST MOWER CUTTING HEIGHT
The position of the attachment lift lever
determines the cutting height.
, Grasp lift lever.
Press plunger with thumb and move
lever to desired position.
The cutting height range is approximately
1-1/2 to 4". The heights are measured
from the ground to the blade tip with the
engine not running. These heights are
approximate and may vary depending
upon soil conditions, height of grass and
types of grass being mowed.
13
Advertisement
