Cisco Nexus 7000 Hardware Installation And Reference Manual page 290

Replacing a Supervisor Module
Figure 10-9
1 On the second memory slot from the front of
the supervisor module, rotate both spring
clips out.
2 Holding the DIMM by its edges, align it to the
second memory slot and push it into place
until the spring clips click into the DIMM.
Holding the edges of the 4-GB memory board with one hand, slide it into the second memory slot from
Step 10
the front of the module until the two spring clips click into the DIMM (see Callout 2 in
Place an 8-GB label on the front of the module and to the right of the N7K-SUP-1 identifier.
Step 11
Rotate both ejector levers away from the front of the supervisor module.
Step 12
Grasp the front of the supervisor module with one hand and place your other hand under the module to
Step 13
support its weight.
Align the module to the open supervisor slot in the chassis and push the module into the slot until it
Step 14
makes contact with the midplane.
Simultaneously push both ejector levers inward until they come in contact with the face of the module.
Step 15
The module should be fully seated in the slot and the captive screws should be aligned with their holes
in the chassis. The EMI gasket should close the gap between this module and the next module.
Screw in the two captive screws to the chassis and tighten them to 8 in-lb (0.9 N·m).
Step 16
Reconnect the console cable to the CONSOLE SERIAL PORT as explained in the
Step 17
Console" section on page
Step 18 If the previous supervisor module was connected to an asynchronous device through a modem, connect
the modem cable to the COM1/AUX SERIAL PORT as explained in the
section on page
Reconnect the network management cable to the MGMT ETH port as explained in the
Step 19
Management Interface" section on page
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
10-32
Adding a 4-GB DIMM
7-2.
7-2.
7-4.
Chapter 10 Installing or Replacing Components
3 Add an 8 GB label to the right of the
N7K-SUP-1 identifier on the front of the
module.
"Connecting to the Console"
Figure 10-9).
"Connecting to the
"Setting Up the
OL-23069-07