Cisco TelePresence PrecisionHD Camera
Contents
Introduction
PrecisionHD 1080p12x
The information on this page applies to the PrecisionHD 1080p12x
camera. The camera has DIP switches for video output format
setting.
NOTE:
The early shipments of the Quick Set C20 came with
an interim version of the PrecisionHD 1080p4x camera (the
PrecisionHD 1080p4x* camera). The interim version has DIP
switches for video output format setting, see the table on this page.
Video output formats
The DIP switches 1 to 5 set the video output format for the
camera. The DIP switches are located under the camera. The
default setting is Auto, see the table to the right.
Maximum resolution:
•
1080p60 for PrecisionHD 1080p12x zoom
•
1080p30 for PrecisionHD 1080p4x* zoom
•
1080p30 for HD-SDI**
Line voltage frequency
The camera automatically detects the line voltage frequency
when it is 50 or 60 Hz. If there is a different line voltage, you
can set the video output format to a specific value (use the DIP
switches) to override the auto frequency detection.
Set the PrecisionHD 1080p DIP switch (country specific setting):
•
50Hz: 00011, gives 1080p50 (720p50 for HD-SDI)
•
60Hz: 00100, gives 1080p60 (720p60 for HD-SDI)
D14640.12 Cisco Telepresence PrecisionHD Camera User Guide TC6.2, August 2013.
The Physical Interface
Connecting the Camera
DIP switch table
DIP Switch table for video output formats
1
2
3
4
5
0
0
0
0
0
0
0
0
0
1
0
0
0
1
0
0
0
0
1
1
0
0
1
0
0
0
0
1
0
1
0
0
1
1
0
0
0
1
1
1
0
1
0
0
0
0
1
0
0
1
PrecisionHD 1080p12x, from below
25
Daisy Chaining
HDMI
HD-SDI**
Auto
1920x1080p25
1920x1080p25
1920x1080p30
1920x1080p30
1920x1080p50**
1280x720p50***
1920x1080p60**
1280x720p60***
1280x720p25
1280x720p25
1280x720p30
1280x720p30
1280x720p50**
1280x720p50***
1280x720p60**
1280x720p60***
Software control
Video Output Format
Video Output Format
Appendices
The table shows the different settings available
for the HDMI and the HD-SDI outputs.
Auto: Camera negotiates format over HDMI.
HD-SDI tracks HDMI and defaults to 1080p30 in
absence of HDMI sync. This is the default setting.
Software: For more on the Software control set-
ting, read about video mode selections in the
Appendix section. Go
to:Controlling cameras
using the VISCA™
protocol.
* Available for a limited period of time.
** Not supported with Codec C20.
*** Do not use with the PrecisionHD 1080p4x* camera.
The DIP switches 1 to 5
0
1
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
User Guide