GE AJCH 08 ACB Owner's Manual And Installation Instructions page 9

www.GEAppliances.com
Fan Switch
To reach tile tim switch (es) remove tile
fl'ont grille.
On Heat/Cool and Heat Pump models, tile tim switch
leveI_ are located in holes accessed through tile
control box. Tile top switch is fin _COOL settings
and tile bottom sMtch is fin" HEATsettings.
Use a small screwdriver to change tile setting.
Tile trait is shii)ped ti'om tile thctory set in tile
CONTsetting tot COOLand in tile cgCtfsetting
tot HEAT
Cool only models
have a rocker switch on tile
front of tile control box.
_._qaen set at CYCLE (down) tile tim cycles on and
off when cooling. When set at CONT (continuous,
up) tile tim runs all tile time, providing a more
balanced temperature. Tile trait is shiI)ped in
tile CONTsetting.
Temperature Limiting
Limiting tile maMmum and minimum settings
prevents useI_ ti'om ttwning tile control to tile
extreme heat or cool positions.
Tile mmnal range of tile temp control is
approximately 60°F to 85°E Tile control range
may be narrowed by the use of tile temperattu'e
limiting screws located behind tile control panel.
@
@ @
@
Limits
heat cool
temp temp
Each position equals approximately 3°E
Vent Control
Tile vent control is located behind tile ti'ont
grille on tile fight side of tile air discharge area.
X,_qlell set at
CLOSE,
onl} tile air inside tile rooln
will be circulated aim conditiolaed. When set at
OPEN, some inside air is exhausted outside.
To oi)ell or close tile vellt:
1. Remove tile front giille.
2. Ren/ove tile vent card scre_:
3. Remove vent card, turla it over and replace
it by locating rear hole in card over locating
pin inside air discharge aim reattaching
screw at Ji'Ollt.
The unit leavesthefactorysetat the CLOSE position.
_hole
OPEN position
(Meshendtowardback)
Screwhc
CLOSE position
(Meshendtowardfront)
A# Direction
HolJzoHt _] ]olwers
let voll coH[i'o] [])e
air direcd(m iq:_
_tm?(] dow]L
Remove tile [_'o_1[
grille
t _ a(!jl_st tl_e
vertical ]om'ers
side-to-side
to
di rect tile ai r ]eft
or right,