Setting Bake - Frigidaire Built-In Range Use & Care Manual

Table of Contents

Advertisement

SETTING OVEN CONTROLS
SETTING QUICK OR POWERPLUS
Use the preheat feature when using single rack baking
to quickly heat the oven to bake temperatures. Use this
feature only for standard baking. A reminder tone will sound
indicating when to place the food in the oven.
When the oven is fi nished preheating quick preheat will
become just like the bake feature and continue to bake
until cancelled.
To set the Preheat temperature for 375°F
1. Arrange the interior oven racks.
2. Press PREHEAT. "350" will appear in the display. If a
preheat of 350°F is needed, press START.
3. Press 3 7 5.
4. Press START. "PRE" will be displayed while the oven is
preheating.
18
PREHEAT

SETTING BAKE

TM
The BAKE pad controls normal baking. If a rapid
preheating is preferred, refer to the POWERPLUS
PREHEAT feature for instructions. The oven can be
programmed to bake at any temperature from 170°F to
550°F.
Baking Tips:
• Preheat your oven before using the bake mode.
• During preheat, the bake burner only is used to heat
the oven.
• Use only one rack and center the pans as much as
possible on rack 2 or 3.
• If using two racks, place the oven racks in positions 1
and 3.
• Allow 2" to 4" (5,1 to 10,2cm) around the utensil(s)
for proper air circulation.
• Be sure the pans do not touch each other, the door,
sides or back of the oven.
To set the Bake Temperature to 375°F
1. Arrange interior oven racks.
2. Press BAKE, "350" will appear in the display. If a
bake of 350°F is needed, press START.
3. Press 3 7 5.
4. Press START. The actual temperature will be
displayed. A beep will sound once the oven
temperature reaches 375°F and the display will show
"375°".
5. Place food in the oven.
Pressing CANCEL will stop the feature at any time.
To change the Bake Temperature
(example: changing from 375°F to 425°F)
1. After the oven has already been set to bake at 375°F
and the oven temperature needs to be changed to
425°F, press BAKE and "375" will appear in the
display.
2. Press 4 2 5.
3. Press START.
NOTE
TM

Advertisement

Table of Contents
loading

Table of Contents