Programmed Edit Recording - Aiwa Z-M260 Operating Instructions Manual

PROGRAMMED EDIT RECORDING

Programmed edit function enables CD recording while checking
the remaining time on each side of the tape as the tracks are
programmed.
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded from the beginning of
either side.
Use the remote control from steps 3 to 8.
1 Insert the tape into Deck 2, and press the DOLBY
NR button to turn Dolby NR on or off.
Insert the tape with the side to be recorded on first facing out
from the unit.
2 Press the CD button and load the disc(s).
3 Press the EDIT/CHECK button twice.
"EDIT" lights up and "PRGM" appears on the display.
4 Press the numeric buttons to designate the tape
length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press the 6 and 0
buttons.
Tape length
5 Press the DIRECT button, then press one of the
numeric buttons 1 to 5 within 3 seconds to select
a disc, and press the numeric buttons to program
a track.
Example: To select the 10th track of disc 2, press the DIRECT
button and the numeric button 2, then the numeric buttons
+10 and 0.
EDIT
Maximum recording
time for side A
Tape side A (front side)
6 Repeat step 5 for the rest of the tracks for side A.
A track which has a playing time longer than the remaining
time cannot be programmed.
7 Press the EDIT/CHECK button to select side B
and program the tracks for side B.
After confirming B on the display, repeat step 5.
Tape side B (reverse side)
8 Press the iREC/REC MUTE button and then
press the k button within 2 seconds to start
recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front side A ends, recording
on the back side B starts.
To stop recording
Press the a button. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press the EDIT/CHECK button to select side
A or B, and press the c or d button repeatedly.
Program number
Track number
To change the program of each side
Press the EDIT/CHECK button to select side A or B, and press
the aCLEAR button to clear the program of the selected side.
Then program tracks again.
To clear the edit program
Press the aCLEAR twice so that "EDIT" disappears on the
display.
Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
Remaining time of side A
Programmed
Total number of
track
programmed
numbers
tracks
Programmed
track numbers
16
ENGLISH
En
C
A