Table of Contents
Advertisement
Slidetheupper endofa Handrail (85)intotheright
Upright ( 82)asshown. N ote:It will be necessary to
pivot the Handrail to the side and back repeatedly
(see arrow A) while pushing on the Handrail (see
arrow B) to slide it fully into the Upright. Next, pivot
the lower end of the Handrail down, push it toward the
right Upright, and then align it with the indicated hole.
Slide the other Handrail (85) into the left Upright (82) as
described above.
Hole
,
With the help of a second person, carefully tip the
Uprights (82) down as shown. Make sure that the
Extension Legs (103) remain in the Uprights.
Tighten a Handrail Bolt (78) with a Handrail Washer (96)
into each Extension Leg (103) and Handrail (85) as
shown. Note: Refer to figure 4b. To align the hole in the
Handrail with the hole in the Extension Leg, it may be
necessary to move the Handrails up or down or have a
second person stand on the treadmill and lift the
Handrail.
Next, attach each Extension Leg (103) with two Short
Screws (101) as shown.
With the help of a second person, carefully tip the
Uprights (82) back to the upright position.
4
96
85
103
7101
,
78
Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 17). To protect the floor or carpet
from damage, place a mat under the treadmill.
Advertisement
Table of Contents
