ProForm 595LE 831.297773 User Manual page 6

6
4. While a second persoo holds theRight Handrail (85) and
theCo ote Base ( ..ear the UpdOht ( 82),cutthe
Indicated plas_ic'tios off the Right Handmll. Do not cut
the other plastic tie off the Right Handrail. Next, cut
the plastic tie off the Upright Wire Harness (34) in the
dght Upright (&_), Do not drop the Up.right Wire
Harness into the right Upright.
Refer to the Inset drawing. Connect the Upright Wire
Hamess (34) to the Console Wire Harness (48). The
latch on the Console Wire Harness should snap onto the
Updght Wire Harness. If the Wire Harnesses do not fit
together easily, turn them; do not force the Wire
Hamasses together. Next, connect the dght pulse wire
(with the 'l:f'.tag), the left pulse wire, and the ground wire
to the corresponding connectors on the Console Wire
Harness (48); make sure that the wires with tags are
connected to each other.
5: Nots that thel;e is still a plastic tie in the Right
: Handrail (85); do not remove this plastic tie.
:Position the Right Han_:lrait(85) on the right Updght (82)
as shown. The bracket on the bass of the dght Upright
should be Inside of the lower end of the dght Handrail, as
shown In the Inset drawing.
While holding the Console Base (87) near the Right
Handrail (85), feed the Console Wire Hamess (48) into
the Right Handrail. Next, place the Console Base on the
Handrails (74, 85). Insert any remaining Console Wire
Hamess Into the Right Handrail.
, Thread two Handrail Bolts (78) with Handrail Washers
(36) Into the Left Handrail (74) and the left Updght (82) as
shown. Do not tighten the Handrail Bolts yet. Next,
thread two Handrall Bolts (78) with Handrail Washers
(36) into the Right Handrail (85) and the dght Upright
(82). Do not tighten the Handrail Bolts yet. Be careful
to avoid damaging the Console Wire Harness (48).
6. Attach the Console Base (87) to the Left and Right
Handrails (74, 85) with four Long Screws (114).
Refer to assembly step 5. Tighten the four Handrail
Bolts (78) used in assembly step 5.
Press two Small Upright Plugs (79) into the holes near
the upper ends of the Uprights (82).
7. Remove the backing from the Adhesive Clip (99). Press
the Adhesive Clip onto the base of the dght Updght (82)
as shown. Press the Allen Wrench (100) into the
Adhesive Clip.
8. Make sure that all parts are tightened before you
use the treadmill. To protect the floor or carpet, place
a mat under the treadmill
4
Do not
Ground
85
-Cut Plastic Tie
5
7 •
Donot
Remove
this
Tie
36
6 87___=__
\\ II
99 100