Electrical Requirements - DeLonghi EC 152 CD Instructions For Use Manual

Hide thumbs

Table of Contents

Before using this appliance ensure that the voltage indicated on the product corresponds

with the main voltage in your home, if you are in any doubt about your supply contact your

local electricity company.

The ﬂexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13

amp capacity.

Should this plug not ﬁt the socket outlets in your home, it should be cut off and replaced with

a suitable plug, following the procedure outlined below.

Note: Such a plug cannot be used for any other appliance and should therefore be properly

disposed of and not left where children might ﬁnd it and plug it into a supply socket - with

the obvious consequent danger.

Please note: We recommend the use of good quality plugs and wall sockets that can be

switched off when the machine is not in use.

IMPORTANT: The wires in the mains lead ﬁtted to this appliance are coloured in accordance

with the following code:

GREEN AND YELLOW

BLUE

BROWN

As the colours of the wires in the mains lead of this appliance may not correspond with the

coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured green and yellow must be connected to the terminal in the plug which is

marked with the letter E or by the earth symbol

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or

coloured black.

The wire which is coloured brown must be connected to the terminal which is marked with the letter L

or coloured red.

When wiring the plug, ensure that all strands of wire are securely retained in each terminal.

Do not forget to tighten the mains lead clamp on the plug. If your electricity supply point has

only two pin socket outlets, or if you are in doubt, consult a qualiﬁed electrician.

Should the mains lead ever require replacement, it is essential that this operation be carried

out by a qualiﬁed electrician and should only be replaced with a ﬂexible cord of the same

size.

After replacement of a fuse in the plug, the fuse cover must be reﬁtted. If the fuse cover

is lost, the plug must not be used until a replacement cover is obtained. The colour of the

correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or

elsewhere on the plug. Always state this colour when ordering a replacement fuse cover.

Only 13amp replacement fuses which are asta approved to B.S. 1362 should be ﬁtted.

This appliance conforms to the Norms EN 55014 regarding the suppression of radio inter-

ference.