Table of Contents
Advertisement
WHEN YOU MOVE
When you are moving your refrigerator
to a new home, follow
these steps to prepare
it for the move.
1. Remove all food from the refrigerator
and pack all frozen
food in dry ice.
2. Unplug
refrigerator.
3.Clean
refrigerator,
wipe, and dry well.
4.Empty
water
from the defrost
pan.
5.Clean,
wipe and dry thoroughly.
6.Take out all removable
parts, wrap them well and tape
together
so they do not shift and rattle during the move.
Refer to sections in Using Your Refrigerator
for removal
instructions.
7. Depending
on the model,
raise the front of the refrigerator
so it rolls more easily OR screw in the leveling
legs all
the way so they do not scrape the floor. See the DOOR
ALIGNMENT
section.
8.Tape the doors shut and tape the power cord to the
refrigerator
cabinet. When
you get to your new home,
put everything
back and refer to the REFRIGERATION
INSTALLATION
section for setup instructions.
9.If the ambient
temperature
will drop below freezing,
have
a qualified
service technician
drain the water
supply system
(on some models) to prevent serious property
damage
due to possible flooding
from ruptured
water
lines or
connections.
When you get to your new home, put everything
back and
refer to the REFRIGERATOR
INSTALLATION
section for setup
instructions.
ICEMAKER
OPERATION
Personal
Injury
Hazard
Avoid contact
with the moving parts of the ejector
mechanism,
or the heating
element
that releases the
cubes. DO NOT place fingers or hands on the automatic
icemaking while the refrigerator
is plugged
in.
A newly=installed
refrigerator
may take 12 to 24 hours to
begin
making
ice.
Indicator
Light
\
Shutoff Arm
Ice Cube size
Power Switch
selector
button
The icemaker will produce
6 cubes per cycle, approximately
100 cubes in a 24 hour period,
depending
on freezer
compartment
temperature,
room temperature,
number of door
openings
and other operating
conditions.
If the refrigerator
is used before the water
connection
is made to the icemaker,
set the power switch to OFF (O). Throw away the first few
batches
of ice to allow the water
line to clear.
Be sure nothing interferes
with the sweep of the feeler arm.
When the bin fills to the
level
of
the feeler arm, the icemaker
will stop producing
ice.
It is normal
for several cubes to be stuck together.
If ice is not
used frequently,
old ice cubes will become
cloudy, taste stale,
and shrink.
WHEN SHOULD YOU SET THE ICEMAKER
POWER SWITCH
TO OFF
° When the water
supply will be shut off: for several hours.
° When the
ice
storage bin is removed
for more than a minute
or two.
° When the refrigerator
will not be used for several days.
NORMAL
SOUNDS YOU MAY HEAR
° The icemaker water valve wiii buzz as the icemaker
flits with
water. If the power switch is in the ON (I) position, it will
buzz even if it has not yet been hooked
up to water. To stop
the buzzing,
move the power switch to OFF (O) position.
NOTE: Keeping
the power switch in the ON (I) position
before
the water
line is connected
can damage
the icemaker.
° You will hear the sound of cubes dropping
into the bin and
water
running in the pipes as the icemaker
refills.
24
Advertisement
Table of Contents
