Measuring Ac Or Dc Current; Measuring Frequency - Agilent Technologies U1231A User Manual

Measuring AC or DC Current

WA R N I N G
C A U T I O N
N O T E
U1231A/U1232A/U1233A User's Guide
Set up your multimeter to measure AC or DC current as
shown in Figure 2- 24
and read the display.
Never attempt an in-circuit current measurement where the
open-circuit potential to earth is greater than 1000 V. Doing so will
cause damage to the multimeter and possible electric shock or
personal injury.
To avoid possible damage to the multimeter or to the equipment under
test:
• Check the multimeter's fuses before measuring current.
• Use the proper terminals, function, and range for your
measurement.
• Never place the probes across (in parallel with) any circuit or
component when the leads are plugged into the current terminals.
• To measure current, you must open the circuit under test, then place
the multimeter in series with the circuit.
• Insert the black test lead into the COM terminal. Insert the red test lead
in an input appropriate for the measurement range.
• Set the positive input terminal to the A terminal and set the rotary switch
for currents above 600 μA.
position to Hz
Set the positive input terminal to the mA terminal and set the rotary switch
•
position to Hz
• Press to cycle between DC current measurement, AC current
measurement, or to measure the frequency of the AC current source.
See

"Measuring Frequency"

Making Measurements
Measuring AC or DC Current
and Figure 2- 25. Probe the test points
for currents below 600 μA.
on page 62 to learn more.
2
57