Kenmore 116.21714 Use & Care Manual page 25

TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your
vacuum cleaner, the agitator must be
cleaned every time the belt is changed.
The agitator must also be cleaned
according to the following schedule:
Vacuum Cleaner Use Clean A¢itator
HEAVY . every week
(used daily)
MODERATE -
(used 2-3 times!week)
LIGHT -
(used ] time/week)
every month
every 2 months
IMPORTANT
Disconnect vacuum cleaner from electrical
outlet. Check and remove hair, string and
lint build-up frequently in the PowerMate
agitator and end cap areas.
Remove any dirt or debris in the belt
path area or in the brush roller area.
Carefully remove
any string or
debris located
on the agitator
or end caps. _,
AGITATOR ASSEMBLY
-End Cap
Brush Unit End Ca
TO REPLACE BELT
NOTE: Use replacement belt STYLE CB-3,
see part number detail in REPLACEMENT
PARTS (page 5).
1, Install new
belt over
motor drive, Drive
then over
belt path. Path
Agitator
2. Place agitator
assembly into
PowerMate.
3, NOTE: Be sure that the dirt sensor
board is positioned in slots and all wiring is
tucked back in place.
4. Line up front of cover and base. Rest
cover on front edge of base as shown.
5. Rotate cover
back, Press cover
firmly until side
latches snap Into
place.
6, Make sure there is no gap between the
cover and base and that the rear latches
are snapped in place.
Z Turn PowerMate upside down and replace
four (,4) cover screws.
25