Table of Contents
Advertisement
TROUBLESHOOTING
Most treadmill
problems can be solved by follow-
ing the simple steps below. Find the symptom that
applies, and follow the steps listed, if further assis=
tance is needed, see the front cover of this manual.
SYMPTOM: The power does not turn on
a,
Make sure that the power cord is plugged into a
surge suppressor and that the surge suppressor
is plugged into a properly grounded outlet (see
page 13). Use only a surge suppressor that meets
all of the specifications described on page 13.
iMPORTANT: The treadmill
is not compatible
with GFCl=equipped outlets and may not be
compatible with AFCl=equipped outlets.
b.
After the power cord has been plugged in, make
sure that the key is inserted into the console.
C,
Check the power switch located on the treadmill
frame near the power cord. If the switch protrudes
as shown, the switch has tripped. To reset the
power switch, wait for five minutes and then press
the switch back in.
c
Tripped
Reset
SYMPTOM: The power turns off during use
a.
Check the power switch (see the drawing above).
If the switch has tripped, wait for five minutes and
then press the switch back in.
b.
Make sure that the power cord is plugged in. If the
power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c.
Remove the key from the console, and then
reinsert it.
d.
If the treadmill still will not run, please see the back
cover of this manual.
SYMPTOM: The console displays
remain lit when
you remove the key from the console
a,
The console features a display demo mode,
designed to be used if the treadmill is displayed in
a store. If the displays remain lit when you remove
the key, the demo mode is turned on. To turn off
the demo mode, hold down the Stop button for a
few seconds. If the displays are still lit, see THE
INFORMATION
MODE on page 18 to turn off the
demo mode.
SYMPTOM: The incline of the treadmill
does not
change correctly
a,
Hold down the Stop button and the Speed increase
button, insert the key into the console, and then
release the Stop button and the Speed increase
button. Press the Stop button and then press the
Incline increase or decrease button. The tread-
mill will automatically
rise to the maximum incline
level and then return to the minimum level. This will
recalibrate the incline system. If the incline does not
begin calibrating, press the Stop button again, and
then press the Incline increase or decrease button
again. When the incline is calibrated, remove the
key from the console.
SYMPTOM: The upper body arms squeak during
use
a,
(Note: Correcting this problem requires a small
amount of marine grease, available at hardware
stores.) Turn the resistance knob (A) counterclock-
wise and remove it. Next, remove the resistance
cone (B) and the upper body arm (C), along with
the resistance plate (D), plastic spacer (E), spring
washer (F), washers (G), and thrust bearing (H).
(Note: If the resistance plate comes out of the
resistance cone, press it back in.) Apply a thin layer
of white marine grease to the outer surface of the
resistance cone. Then reattach all parts in the order
shown below.
E
D
F
G
H
2O
Hide quick links:
Advertisement
Table of Contents
