Kenmore W10026587A Quick Start Manual page 2

Ultra Clean with Soak Soak
Use this cycle for sturdy or heavily soiled loads. This cycle
includes a 5-minute soak to help improve cleaning.
• Approximate cycle time: 60 minutes
Normal
Select this cycle for cottons and linens used regularly. The
fast-speed spin shortens drying time.
• Approximate cycle time: 40 minutes
Permanent Press
Use this cycle to wash no-iron/permanent press fabrics. This
cycle provides an additional load-cooling spray rinse to
reduce wrinkling.
• Approximate cycle time: 30 minutes
Delicate
This cycle combines slow-speed agitation and slow-speed spin
to gently clean garments while reducing wrinkles.
• Approximate cycle time: 25 minutes
This cycle features agitation followed by unlimited soak time to help
remove stains that need pretreatment. After soaking, you have two
options. To use the same water in a wash cycle, advance the Cycle
Selector (]qmer) Control knob to a wash cycle. To remove the soak
water, reset the washer to a Spin setting. If the Soak water was drained,
add more detergent to the wash cycle.
NOTE: Be sure to push the control in to change to another cycle and
set. Pull the control out to start the washer in its selected cycle.
Prewash
This cycle helps to remove heavy soils that need pretreatment. This
cycle should be followed by a wash cycle. Add more detergent to the
wash cycle. The Prewash cycle does not include a rinse.
• Approximate cycle time: 12 minutes
2nd Rinse
A second rinse can be used to aid in improved removal of detergent or
bleach residue from garments. This option may be automatically added
to the wash cycle by setting the OPTIONS Control to 2nd Rinse any-
time before the end of the cycle.
Handwash
Use this cycle for special care items. This cycle features a
series of brief agitation and short soaks for gentle cleaning
and minimal wrinkling.
• Approximate cycle lme: 25 minutes
Rinse & Spin
Select this option if you think an extra rinse is needed. Set OPTIONS
Control to 2rid Rinse. You should then set the Cycle Selector (Timer)
Control knob to a 2nd Rinse setting.
Spin Only
A drain and spin may help shorten drying times for some fabrics by
removing excess water. Set OPTIONS Control (if available) to One
Rinse. You should then set Cycle Selector (Timer) Control to a Spin
setting, j
SIIL L£Y£1.. W II lIB,lillY
One Rinse
This is the rinse at the end of each cycle.
2nd Rinse
Choose this option for an automatic 2nd rinse cycle.
TIIIIZ£$111TIII
- $11115
LEIR$
Before you call service...check for the following.
Loud clicking and banging?
• The yellow shipping strap may still be in the rear of the
washer. Completely remove the yellow shipping strap.
• The washer should be level, and the feet should be firmly
on the floor.
Some sounds are normal but may be different from
those of your previous washer.
• The gears engaging after the drain and before the spin.
• The sound of air being pulled through the pump after most
of the water has drained.
Is the washer leaking?
• Fill hose connections are tight
• Gaskets in fill hose are tight and fiat
• Drain hose clamp is securely attached
• Faucets, drain/standpipe or laundry tub is not leaking
• The washer tub is centered, and the load evenly balanced
at the start of each load
• The washer is level
• The front feet are installed, and the nuts are tightened
to the cabinet
See the Use and Care Guide for complete details.
W10026587A
e Registered Trademark / TM Trademark / SM Service Mark of 12/06
@ 2006 Sears Brands, LLC. Sears Brands_ LLC, used under licensee by Sears Canada Inc. Printed in U.S.A