GE Profile Advantium SCB2000CBB Dimension Manual

0
Profi/e/ r nce Seri
SCB2000CBB - Advantium Wall Oven
Dimensions (in inches)
18"
15-27/32"_25/32 _
*Excludinghandle
27/32'4]_
14-_[_ 9/16"
20-27/32" _ "',,
27/32" ',
13"_
7/8" 15/32" 4_r11/16"
Electrical Requirements
Single SpeedcookInstallation
Product r ating is 120/208or 120/240volt, 60 Hz,30 Amps.This productmustbe connectedto a supplycircuit
of the propervoltageandfrequencyandprotectedby a time delayfuse or circuit breaker.The powersupply
shouldbe broughtto a separate30 amperebranchcircuit. Wire sizemustconformto the requirements of the
NationalElectricCodeor the prevailinglocal code.
CombinedSpeedcookand Wall Oven Installation:
When installed in combination with a GEsingle wall oven, use separate electrical iunction boxes,
OR,
Install a single junction box connected to 50 amp. supply circuit or properly rated supply circuit.
• Refer to single oven installation instructions for electrical requirements of
that product.
• These connections must be made by a qualified electrician. All electrical
connections must meet National Electrical code or prevailing local codes.
CombinedSpeedcookand Warming Drawer installation:
When installing the Speedcook oven over a GEelectric warming drawer, a separate 120V,6OHz,
properly grounded receptacle must be installed. See instructions packed with the warming drawer.
Specification Revised10/00
Installation Requirements
• These ovens may be installed directly into a wall or wall oven cabinetry,
30"minimum width.
• The front surface of the oven will be nearly flush with surrounding cabi-
netry doors.
• This oven can be installed over any GEsingle electric bugt-in oven or a
single GEelectric bugt-in warming drawer.
• This oven must be installed at least 36"above the floor.
IMPORTANT:This oven is not approved for use above another
built-in Speedcook oven, side by side or under the countertop
installations.
• For personal safety, this oven cannot be installed in a cabinet arrange-
ment such as an island or peninsula.
•Cabinets installed adiacent to wall ovens must have an adhesion spec of
at least 194°Ftemperature rating,
•Allow for clearance to adjacent corners, walls, drawers, etc.
Foranswersto yourMonogram_
GEProfilePerformance Seriesl "
GEProfile
TM
or GEappliancequestions,call
GEAnswerCenteP service, 8 00.626.2000.
Listedby
UnderwUters
Laboratories