Preparation Of Top Cabinet; Adapting Blower For Outside Back Exhaust - GE JVM1490 Installation Instructions Manual

Installation Instructions
To use toggle bolts:
Spacingfer Tu!NlesMore
_ ThanWaft Thickness
ITe_lsw,n_s
M_um:ing i 7 I"
• ', 0!N e ,
'a e41.'l,.Zgo, II I:1-,
" I't
II U I
golt End
[] Place dm mounting plato _ainst the wall and
insert the toggle wings into the holes in the wall
to mount the plate,
NOTE: getbre tightening toggle bolts and wood
screw; make sure the tabs on the mounting pla_
touch (he bottom of"the cabinet when pushed flush
against the wall and that the plate is properly
centered trader the cabinet,
CAUTION: Be caref'uI to avoid pinching fingers
between the back of' the moun ling plate and dm wall,
[] Tighten all bolts, Pull the plate awW from the wall
to help tighten the bolts,
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes fbr the top support screws and
a hole lm:ge enough fbr the power cord to fit through,
%
%
• Read tim instructions on the TOP CABINET
"rI?]MPIz\TE.
• Tape it underneath (he mp cabinet.
• Drill the hoIes, fbllowing the instructions on the
TOP CABINET "rI?;MPI J\TE.
CAUTION: WEar safe g goggles when drilling holes
in the cabinet bottom,
F-_ ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
[] Remove the three
scr_wcs that hold the blower
plate to (he oven. Slide blower plate from trader
its retaining flange. Remove and save (he screw
that holds Mower motor to oven.
glower Rate
_ (]areftfily tim blower unit. The wires
puI1 out
will extend Jar enough to allow you to adjust
the blower unit,
EndB
_ Rotate blower unit counterclockwise 180%
Be[oreRototion After Rototion
Oven
gockof
Oven
[] (_ntly remove the wires fi:om the grooves,
Reroute the wires through grooves on other side
of"the blower unit,
Be[oreRerouting Aher Reroudng
16