Using A Phone Modem - Acer Ferrari 3400LMi Manual

F8­x86_64 on the Acer Ferrari 3400LMi
...
... kernel: usb 4­2: new full speed USB device using uhci_hcd and
address 4
... kernel: usb 4­2: configuration #1 chosen from 1 choice
... hcid[1963]: HCI dev 0 registered
... hcid[1963]: HCI dev 0 up
... hcid[1963]: Device hci0 has been added
... hcid[1963]: Starting security manager 0
... hcid[1963]: Device hci0 has been activated
...
The blue led indicator should start blinking as well. Now verify that your
bluetooth device is up and running:
# hciconfig ­a
hci0: Type: USB
BD Address: 00:0E:9B:87:3B:90 ACL MTU: 192:8 SCO MTU: 64:8
UP RUNNING PSCAN
RX bytes:940 acl:0 sco:0 events:23 errors:0
TX bytes:586 acl:0 sco:0 commands:22 errors:0
Features: 0xff 0xff 0x0f 0x00 0x00 0x00 0x00 0x00
Packet type: DM1 DM3 DM5 DH1 DH3 DH5 HV1 HV2 HV3
Link policy: RSWITCH HOLD SNIFF PARK
Link mode: SLAVE ACCEPT
Name: 'redneck.superwise.net­0'
Class: 0x100100
Service Classes: Object Transfer
Device Class: Computer, Uncategorized
HCI Ver: 1.1 (0x1) HCI Rev: 0x20d LMP Ver: 1.1 (0x1) LMP Subver:
0x20d
Manufacturer: Cambridge Silicon Radio (10)
If you have come this far without any problems you are all set and ready to go.

13.2 Using a phone modem

To help get you started I have summarized the basic steps to hook up your
bluetooth capable phone as a modem. I am using a Sony Ericsson P900 myself,
but the steps are general so it should work for most bluetooth phones.
The steps below are exactly the same whether you intend to connect to a remote
modem or connect over GPRS. When connecting over GPRS the phone also needs
to be connected and recognized as a modem. It is the actual dialing later on in
the process that differs.
With FC4 and FC5 I experienced some issues with the PIN­helper, i.e. the dialog
window that prompts for a PIN code. However, no such issues has been observed
with Fedora 8.
27