Film Rewinding; Manual Film Advance - Nikon MD-12 Instruction Manual

FILM REWINDING

When the roll of film in the camera has been fully exposed, the
MD-12's motor will automatically stop, releasing film tension,
with the pilot lamp remaining lit. Turn the power switch off to
prevent unnecessary battery drain. Then, push the rewind slide
on the motor drive up. Rewind the film normally. See your
camera's instruction manual for details.
Distributed by WWW.LENSINC.NET

MANUAL FILM ADVANCE

If at any time you wish to manually advance the film without
removing the MD-12 from the camera, turn off the motor drive's
power switch after it has finished advancing the film from the
previous exposure. Then, in the case of the FM (Serial No. be-
low 3,000,000), turn the mode selector switch so that the black
line (white, on black camera bodies) is adjacent to the line on
the camera body. As for the FM (Serial No. over 3,000,000) or
the FE, it switches automatically from motor drive to manual
film advance operation when the motor drive is switched off.