Install Batteries And Check Battery Power; Install Batteries And Check Battery Power - Nikon F60 Instruction Manual

Install Batteries and Check Battery Power

1
Use two CR123A or DL123A-
type lithium batteries with this
camera. (Other batteries cannot
be used.)
1. Turn off the main switch and open the battery
1
chamber cover.
1.
Insert batteries with the "+" and "-" ends
2
positioned as marked inside the battery chamber
cover, then firmly close the battery chamber cover.
• Incorrect positioning of + and - poles may cause damage to the
camera.
14
y Check points
i Keep the batteries out of children's reach. If swallowed, contact a
doctor immediately. (For "Notes on Batteries", see page 69.)
i When replacing batteries, be sure to turn the main switch off and
replace both batteries at the same time. Always use fresh batteries of
the same brand.
i We recommend that you take spare batteries with you, especially when
traveling, since the batteries used may be difficult to obtain in some
areas.
1. Turn on the main switch and confirm battery power
3
with the I indication.
• Shutter speed and aperture indications in the LCD panel and viewfinder
automatically turn off 5 sec. after turning the main switch on and camera
is left unused.
• Battery power
I appears: Sufficient battery power.
O appears: Batteries are nearing exhaustion. Have a fresh set ready.
O blinks: Batteries are exhausted. Replace batteries. (No indication
appears in the viewfinder and shutter locks.)
1. Lightly press the shutter release button to activate
4
the exposure meter.
• Lightly pressing the shutter release button reactivates the exposure meter
and shutter speed and aperture indications in the LCD panel and
viewfinder. The indications automatically turn off 5 sec. after you remove
your finger from the shutter release button.
15