Important Safety Instructions; Product Record; Serial Plate Location; Conversion To Liquefied Petroleum Gas - Kenmore 790.46832 Use & Care Manual

Important Safety Instructions
IMPORTANT INSTRUCTIONS FOR USING
YOUR OVEN
• Use care when opening oven door or warmer drawer (if
equipped)--Stand to the side of the range when opening the
door of a hot oven. Let hot air or steam escape before you
remove or replace food in the oven/warmer drawer.
• Keep oven vent ducts unobstructed. The oven vent is
located at the rear of the cooktop. Touching the surfaces in
this area when the oven is operating may cause severe
burns. Also, do not place plastic or heat-sensitive items on or
near the oven vent. These items could melt or ignite.
• Placement of oven/warmer drawer (if equipped) racks.
Always place oven racks in desired location while oven/
warmer drawer (if equipped) is cool. If rack must be moved
while oven is hot use extreme caution. Use potholders and
grasp the rack with both hands to reposition. Do not let
potholders contact the hot heating elements in the oven/
warmer drawer (if equipped). Remove all utensils from the
rack before moving.
• Do not use the broiler pan without its insert. The broiler
pan and its insert allow dripping fat to drain and be kept away
from the high heat of the broiler.
• Donotcoverthebroilerinsertwithaluminum foil. Exposed
fat and grease could ignite.
• Do not touch a hot light bulb with a damp cloth. Doing so
could cause the bulb to break. Disconnect the appliance or
turn off the power to the appliance before removing and
replacing light bulb.
accumulate on hood or filter. Greasy deposits in the fan could
catch fire. When you are flaming food under the hood, turn the
fan on. Refer to the hood manufacturer's instructions for
cleaning.
• Kitchen cleaners and aerosols--Always follow the
manufacturer's recommended directions for use. Be aware
that excess residue from cleaners and aerosols may ignite
causing damage and injury.
SELF CLEANING OVENS
• In the self-Cleaning cycle only clean the parts listed in this
Use and Care Guide. Before self cleaning the oven, remove
the broiler pan and any utensils or foods from the oven.
• Do not use oven cleaners--No commercial oven cleaner or
oven liner protective coating of any kind should be used in or
around any part of the oven.
• Do not clean door gasket--The door gasket is essential for a
good sea]. Care should be taken not to rub, damage or move
the gasket.
Remove oven racks. Oven racks color will change if left in _
the oven during a self-cleaning cycle.
• I_'_'_ The health of some birds is extremely
sensitive to the fumes given off during the self-cleaning
cycle of the range. Move the birds to another well
ventilated room.
Z
IMPORTANT INSTRUCTIONS FOR CLEANING
YOUR RANGE
• Clean the range regularly to keep all parts free of grease
that could catch fire. Exhaust fan ventilation hoods and
grease filters should be kept clean. Do not allow grease to
IMPORTANT SAFETY NOTICE
The California Safe Drinking Water and Toxic Enforcement Act
requires the Governor of California to publish a list of
substances known to the state to cause cancer, birth defects or
other reproductive harm, and requires businesses to warn
customers of potential exposure to such substances.
Product Record
(See Serial Plate Location below)
Model No. 790.
Serial No.
Date of Purchase
READ AND SAVE THESE INSTRUCTIONS.
Save your sales receipt for future reference.
Serial Plate Location
You will find the model and serial number printed on the serial
plate. The serial plate is located on the right side panel of the
drawer and visible when the drawer is open. Please see the
illustration for exact location. Remember to record the serial
number for future reference (See Product Record above).
Conversion to Liquefied Petroleum Gas (also
known as LP. Gas)
The natural gas range is designed to allow for conversion to
Liquefied Petroleum (L.P.) Gas. Contact Sears Service for
assistance. The L.P. Conversion Kit is provided with this
range and is located on the right panel (right side) of the range.
Before installing the kit be sure to follow the L.P. Installation
Instructions carefully.
Open the drawer,
Serial plate is
located here
5