GE Monogram ZGU384N Installation Instructions Manual page 12

Installation Options
COOKTOP INSTALLATION WITH A
30" MONOGRAM DOWNDRAFT VENT,
MODEL ZVB30
The installation of the downdraft vent with
this cooktop requires careful consideration.
Both the cooktop and the vent must be installed
according to each specific installation instruction.
For accurate planning, review the Downdraft
Vent Installation Instructions in advance;
order Pub. No. 49-80!85.
COOKTOP REQUIREMENTS
The countertop must have a deep flat surface to
accommodate the cooktop and vent. Countertops
with a rolled front edge and backsplash will not
provide the flat surface area required.
• Review the illustration to determine the countertop
surface requirements.
- All cutout clearances for this installation must be
observed.
ca'- . .
c ut;tht Rlr'e?;C°tktt p ' t3o;1at',1,2 '
19-5/8"
cooktop
cutout 7/16" cooktop overlap
depth (1-1/4" at center)
........................................................ . ................ .-]
_ Front edge of countertop
2-1/2" min. clearance
to cutout
surface
required
at center
12" min. cutout to
wall, both sides
BASE CABINET REQUIREMENTS
The combined installation will fit in a standard
2/4" deep base cabinet. Use a 30" or wider base
cabinet.
- The vent housing, blower and ductwork will
occupg the base cabinet.
POWER SUPPLY
If local codes permit, the vent and cooktop mag
operate from the same 120V, !5 amp duplex outlet.
Locate the gas and electrical supplg as shown on
page 8.
12