Making Espresso Or Long Coffee Using Pre-Ground Coffee; Making Drinks With Milk; Filling And Attaching The Milk Container; Making Latte - DeLonghi Fully Automatic Coffee Center Machine ESAM6700 Instructions For Use Manual

the cup used. Put the cup for long coffee
under the spouts (fig. 18);
3. Choose the strength by hitting the
and size by hitting the
4. Press the LonG icon (fig. 10). Preparation
begins. A progress bar appears on the display
and gradually advances as the procedure
progresses.
Information:
• While the machine is making coffee, delivery
can be interrupted at any moment by pressing
the LonG icon.
• Only one cup of long coffee can be made at a
time.
• When delivering more than 4.2 oz, the
appliance automatically grinds more coffee
halfway through delivery.
making espresso or long coffee using pre-
ground coffee
Important!
• Never add pre-ground coffee when the
machine is off or it could spread through the
inside of the machine and dirty it.
• Never use more than one level measuring
scoop or it could dirty the inside of the
machine or block the funnel.
Information: If you use pre-ground coffee,
you can only make one cup of coffee at a time.
1. Press the
until "Pre-ground" flashes on the display.
2. Put one level measuring scoop of pre-ground
coffee into the funnel (fig. 19).
3. Place a cup under the coffee spouts.
4. To make espresso coffee, press the one cup
icon (fig. 9). To make a long coffee,
press the LonG icon (fig. 10).
Information: LonG CoFFEE: when deliver-
ing more than 4.2 oz, the appliance requests a
new level measure of pre-ground coffee halfway
through delivery. When you have added the pre-
ground coffee, confirm by pressing the oK icon.
.
icon repeatedly (fig. 7)

mAKInG DrInKS WIth mILK

Filling and attaching the milk container

1. Turn the lid of the milk container clockwise
until it becomes noticeably difficult to turn,
then remove the lid (fig. 20).
2. Fill the milk container with a sufficient
quantity of milk, not exceeding the MAX level
marked on the handle (fig. 21).
Information! We recommend using skim
or 2% milk at refrigerator temperature (about
41°F). To avoid milk with poor froth or large
bubbles, always clean the milk lid and hot water
nozzle as described in the section "Cleaning the
milk container" on page 19.
3. Make sure the milk intake tube is correctly
inserted in the bottom of the milk container
lid (fig. 22).
4. Replace the milk container lid and turn
counterclockwise as far as it will go until you
hear it click.
5. Remove the hot water spout from the nozzle
(fig. 23).
6. Attach the container to the nozzle and push as
far as it will go (fig. 24). The machine emits
a beep when milk container is attached
correctly (if the beep function is enabled).
7. Place a sufficiently large cup under the coffee
spouts and frothed milk spout.
To use particularly tall cups/glasses, raise
the lid (A17) of the special compartment in
the cup tray (fig. 25).

making latte

1. After attaching the milk container,
frothed milk regulator (B1) on lid to position
1 for LATTE (fig. 26).
2. Press the LAttE icon (fig. 27).
The message "Caffelatte... Jug selector in
position: 1" appears. After a few seconds,
frothed milk is delivered from the milk
spout into the cup below. The milk will stop
automatically and delivery of coffee will
begin.
Information: If during delivery you want
to stop preparing milk, press the LATTE icon or
interrupt preparation of the coffee by pressing
the icon.
15
place