FujiFilm FINEPIX S800W Series Owner's Manual page 9

IMPORTANT:
Read the foflowing notices before using the camera's built-in
wireless transmitter.
This product, which contains encryption function developed in the United
States, is controlled by the United States Export Administration Regula
tions and may not be exported or re exported to any country to which the
United States embargoes goods
• Use onlyaspart ofa wirelessnetwork, FUJIFILM does not accept liability for
damages resulting from unauthorized use Do not use in applicatiorls
requiring a high degree of reliability, for example in medical devices or
other systems that may directly or indirectly impact human life When
using the device in computer and other systems that demand a greater
degree of reliability than wireless networks, be sure to take all necessary
precautiorls to ensure safety and prevent malfunction.
• Use only in the country in which the device was purchased. This device con
forms to regulations governing wireless network devices in the country
in which it was purchased Observe all location regulations when using
the device FUJIFILM does not accept liability for problems arising from
use in otherjurisdictions
• Wireless data (images) may beintercepted bythird parties. The security of data
transmitted over wireless networks is not guaranteed
• Do not use the devicein locations subject to magnetic fields, static electricity, or
radio interference. Do not use the transmitter in the vicinity of microwave
ovens or in other locations subject to magnetic fields, static electricity,
or radio interference that may prevent reception of wireless signals Mu
tual interference may occurwhen the transmitter is used in the vicinity of
other wireless devices operating in the 24 GHz band
• The wirelesstra nsmitter operates in the 2,4 GHzband using DSSS and OFDMmodu-
lation.
Wireless Network Devices: Cautions ]
• This deviceoperates on the same frequency ascommercial, educational, and medi-
cal devicesandwirelesstransmitters. It also operates on the salne frequency
as licensed transmitters and special unlicensed low voltage transmitters
used in RFID tracking systems for assembly lines and in other similar ap
plications
• To prevent interference with the above devices, observe the following precau-
tions. Corlfirln that the RFID transmitter is not in operation before using
this device Should you observe that the device causes interference in
licensed transmitters used for fiFID tracking, immediately choose a new
operating frequency for this device to prevent additional interference If
you notice that this device causes interference in low voltage fiFID trac
ing systems, contact a EUJIFILM representative
ix