Display Assembly; Removing The Display Assembly - Dell Studio 1450 Service Manual

Back to Contents Page
Display
Display Assembly
Display Bezel
Display Panel
Display Panel Bracket
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Display Assembly

Removing the Display Assembly

1. Follow the instructions in Before You
2. Remove the system board (see
3. Remove the WWAN module (see
4. Remove the two screws at the base of the computer.
1 screws (2)
5. Remove the four screws (two on each side) that secure the display assembly to the computer base.
Begin.
Removing the System Board).
Removing the WWAN Module).
Removing the Battery) before working inside the