11. Remove the system board from the chassis.
Installing the System Board
1.
Align the system board to the port connectors on the back of the chassis and place the system board in the
chassis.
2.
Tighten the screws securing the system board to the chassis.
3.
Close the expansion-card latch.
4.
Connect the cables to the system board.
5.
Install the
heat
sink.
6.
Install the
expansion
7.
Install the
hard
drive.
8.
Install the
front
bezel.
9.
Install the cover.
10. Follow the procedures in
Removing The PSU Thermal Sensor
1.
Follow the procedures in
2.
Remove the cover.
3.
Disconnect the thermal-sensor cable from the system board.
card.
After Working Inside Your
Before Working Inside Your
Computer.
Computer.
31