Dell XPS 710 Service Manual page 26

1 graphics card bridge 2 power connectors (2)
5. Disconnect any cables connected to the card.
6. Press down the tab on the top of the card retainer at the appropriate card slot and pivot the card retainer back through the chassis wall.
1 release tab 2 card retainer
4 fan bracket
7. Press the release tab (if present) on the system board connector as you grasp the card by its top corners, and then ease the card out of the connector.
NOTE: If the card is full-length, press the release tab on the end of the alignment guides on the fan bracket.
1 PCI Express x16 card 2
8. Install a filler bracket in the empty card-slot opening. If you are replacing the card, see
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the computer. The brackets also keep
dust and dirt out of your computer.
NOTE: The graphics card bridge (not present in all dual-graphics configurations) is not necessary in a single graphics card configuration.
3 dual-PCI Express graphics cards
3 alignment guide
securing tab 3 PCI Express x16 card slot
Installing a PCI Express Graphics Card in a Dual Configuration.