Processor Fan And Heat Sink Assembly; Removing The Processor Fan And Heat Sink Assembly; Replacing The Processor Fan And Heat Sink Assembly - Dell Studio XPS 8100 Service Manual

3. Replace the four screws that secure the chassis fan to the chassis.
4. Connect the chassis fan cable to the system board connector (see
5. Replace the computer cover (see
Processor Fan and Heat Sink Assembly
WARNING: Despite having a plastic shield, the processor fan and heat sink assembly may be very hot during normal operation. Ensure that it has
had sufficient time to cool before you touch it.
CAUTION: The processor fan and heat sink assembly is a single unit. Do not try to remove the fan separately.

Removing the Processor Fan and Heat Sink Assembly

1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Disconnect the processor fan cable from the system board connector (see
4. Place the flat-blade screwdriver in the slot and rotate the four fastner caps in anticlockwise direction to unlock the processor heat sink assembly.
5. Lift the four fastner caps to release the processor heat sink assembly from the system board.
CAUTION: When you remove the processor fan and heat sink assembly, lay it upside down or on its side to avoid damaging the heat sink thermal
interface.
6. Lift the processor fan and heat sink assembly out of the computer.
1 flat-blade screwdriver 2 system board connector
3 slot 4 fastner caps (4)

5 processor fan and heat sink assembly

Replacing the Processor Fan and Heat Sink Assembly

1. Follow the procedures in Before You Begin
System Board
Replacing the Computer Cover).
Begin.
Removing the Computer Cover).
Components).
System Board Components).