Troubleshooting - Canon REBEL SL1 EOS 100D Instruction Manual

Troubleshooting Guide
If a problem occurs with the camera, first refer to this Troubleshooting
Guide. If this Troubleshooting Guide does not resolve the problem,
contact your dealer or nearest Canon Service Center.
Do not recharge any battery pack other than a genuine Canon Battery
Pack LP-E12.
If the battery charger has a problem, the protection circuit will stop the
charging and the charge lamp will blink in orange. If this happens,
unplug the charger's power plug from the power outlet and detach the
battery pack. Attach the battery pack to the charger again and wait a
while before connecting the charger to a power outlet again.
Make sure the battery is properly installed in the camera (p.32).
Make sure the card slot!battery compartment cover is closed (p.32).
Recharge the battery (p.30).
Press the <INFO.> button (p.50).
If the power is turned off while an image is being recorded to the card,
the access lamp will remain on!continue to blink for a few seconds.
When the image recording is completed, the power will turn off
automatically.
331