Microprocessor Module; Removing The Microprocessor Module - Dell Inspiron 8600 Service Manual

Microprocessor Module: Dell Inspiron 8600 Service Manual
Back to Contents Page

Microprocessor Module

Dell™ Inspiron™ 8600 Service Manual

Removing the Microprocessor Module

Installing the Microprocessor Module
Removing the Microprocessor Module
CAUTION: Before performing the following procedures, read the safety instructions
in your Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or
by periodically touching an unpainted metal surface (such as the back panel) on the computer.
NOTICE: Do not touch the processor die. Press and hold the microprocessor down on the
substrate on which the die is mounted while turning the cam screw to prevent intermittent
contact between the cam screw and microprocessor.
NOTICE: To avoid damage to the microprocessor, hold the screwdriver so that it is
perpendicular to the microprocessor when turning the cam screw.
1. Follow the instructions in
2. Remove the keyboard.
3. Remove the fan.
NOTICE: To ensure maximum cooling for the microprocessor, do not touch the heat transfer
areas on the microprocessor thermal-cooling assembly. The oils in your skin reduce the heat
transfer capability of the thermal pads.
4. Remove the microprocessor thermal-cooling
NOTICE: When removing the microprocessor module, pull the module straight up. Be careful
not to bend the pins on the microprocessor module.
5. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam
screw counterclockwise until it comes to the cam stop.
file:///I|/SERVICE%20MANUALS/DELL%20MANUAL...THOUT%20PARALLEL%20SERIAL_SERV_MAN/cpu.htm (1 of 3)6/21/2004 1:14:23 AM
"Preparing to Work Inside the
assembly.
Computer."