Bosch WFMC220BUC Operating Instructions Manual page 9

Supply Line Connection
C Cold water connection and
H Hot water connection
(max. 140 °F / 60 °C)
E3 Plastic threads must only be
tightened by hand when
connecting the water supply hoses
to the back of the unit. Do not
remove the strainers from the
water supply hoses.
In-Wall Installation
After connecting, turn on the water
completely, and check that
connection points are watertight.
The connection points are under full
water pressure. Check seal with tap
fully open.
Water drainage
Do not bend or pull the water
drainage hose.
Height difference between the
installation location of the washing
machine and the drainage point:
Maximum 8 feet / 244 cm,
minimum 2 feet / 60 cm.
Connecting the water
drainage hose
E3 Do not remove the screw from
the clamp assembly. Loosen
the screw only enough so that the
clamp will slide freely onto the
water drain hose.
1. Place the hose clamp over the end
of the drain hose before attaching
the drain hose to the appliance.
2. Attach the drain hose to the drain
hose connection on the back of
the appliance; position the hose
clamp approximately 3/8 inch (9
mm) from the end of the hose.
3. tighten the clamp with a
screwdriver
Standpipe Installation
E3
E3
Use the elbow. Attach the elbow to
the end of the hose and insert end
of hose into standpipe.
Use a strap or cable tie to hold
hose in place.
Use the elbow. Attach the elbow to
the end of the hose and insert the
end of the hose into the wall drain.
The hose and elbow should
extend into the open drain pipe as
far as the elbow allows when
seated as shown in the above
picture.
Use a strap or cable tie to hold
hose in place.
Drainage into a siphon
Secure the connection point with a
hose clip(not included in
factory-supplied equipment).
Drainage into a sink
Ensure that the plug is not in the
drain hole.
Attach water drain hose securely
to sink.
Use a strap or cable tie to hold
hose in place.
When the water is being drained,
check that the water flow out of
the sink is adequate.